TMX 13 Clark electric forklift specs & dimensions (2005 - 2016)

Drive Line

- Reliable “plug-in” drive motor design- Drive axle housing supports pin mounted upright for reduced lost load. “Plug-in” drive motors with heavy mounting flanges mate the splined armature shafts directly to the axle assembly for positive alignment, improved heat dissipation, and reliability. The intermediate gear shaft extends inward, providing an accessible location for the disc brake assemblies.

Brakes

- Responsive pre-reduction disc brake- Long service life. The Carlisle brake system has two disc brake assemblies located externally on the inboard side of the axle housing for easy access. This design provides smooth and responsive braking as brake torque is multiplied 23.4:1, and long brake life is also a benefit. The easy reach hand parking brake mechanically actuates both service brake assemblies.

Steering

- Quiet operation- Full hydrostatic power steering. High maneuverability is achieved with a steering angle of up to 90 degrees and proportional reversing of the inside drive wheel in tight turns. The outside drive tire powers the turn while the inside tire is powered in reverse, enhancing traction on slick or wet surfaces. The heavy-duty steer axle mount with tapered roller bearings provides high durability.

Hydraulic System

- Hydraulic valve has adjustable flow control to accommodate attachment needs- Quick connect port allows convenient pressure check- Continuous fluid filtration- O-ring face seal fittings reduce leaks and are easily serviced Continuous fluid filtration within the power steering system, a 25 micron return line filter and a 10 micron filler cap/breather combine to provide maximum filtering efficiency. The tilt cylinder’s design allows intruck packing replacement.

Uprights

- All-roller construction reduces friction and energy consumption- Lateral side-thrust rollers on the fork carriage reduce friction caused by off-center loads- Full I-section inner and intermediate rails provide maximum section strength- Uprights accommodate 3/8 inch I.D. internal hosing for auxiliary functions requiring high flow rate- Hydraulic cushioning on primary and secondary cylinders CLARK standard and triple stage uprights feature nested rail construction with cylinders behind the rails giving improved operator visibility. Tilt cylinder mounts are self-aligning to minimize side loading on cylinder rods for increased seal life. Hydraulic counter-balance valve in tilt circuit is designed to prevent cavitation. Load lowering and flow limiting control valves regulate carriage lowering speed, even in the event of a line failure. ITA Class II carriages with upset forged hook type forks with retainers.